Duravent Venting System For Direct Vent Pro User Manual

DirectVent ProInstallation InstructionsVenting System For Direct Vent Gas Stoves and Fireplaces

10of 1-1/4 inches. Use the two sheet metal screws provided to secure the Pipe Section to the back of the Termination Cap. The Wall Thimble Cover will

11clockwise, place the left side, the bottom side, and then the right side around the opening in the siding. Refer to Figure 12. With the 4 pieces in

12available in both 1-piece and 4-piece versions.Center the counter ashing on the wall around the fr

13ceilings, walls, roofs, enclosures, attic rafters, or other nearby combustible surfaces. Do not pack air spaces with insulation. Check the applian

14rooine. Galvanized Pipe and Elbows may be utilized in the attic, as well as above the rooine. The galvanized nish is desirable above t

15WALLPLUMBERSSTRAP/TAPE45°ELBOW45°ELBOWDIMENSION FROM TABLE 2"H" OBTAINED adjoining rooines, steep pitched roofs, and ot

16Pipe Sections and the insulation or other debris. For the Attic Insulation Shield, nail the base to oor of attic and adjust shield for appropriate

17the centerline of the venting system on the ceiling and drill a small hole through the ceiling and roof at this point. From the roof, locate the dr

18Sections. Continue to add Pipe Sections until you are above the rooine.Step 8. Follow Steps 7 through 10 (page 15 & 16) of the Vertical Insta

19APPLIANCEADAPTORSUPPORT/WALLTHIMBLE COVER PIPESECTION2 PIECE WALL THIMBLE DECORATIVE CEILINGSQUARE HORIZONTALTERMINATION CAPROUND,



DirectVent Pro is a registered trademark of the M&G DuraVent, Inc.All rights reserved. Made in the USA. M&G DuraVent is a member of M&G G



4These instructions apply to the M&G DuraVent DirectVent Pro 4”x6-5/8” and 5”x8” systems. This venting system, in combination with the

5• Installation other than as instructed by M&G DuraVent or the appliance manufacturer.Consult your local building codes before be

6appliance manufacturer’s installations instructions to determine the minimum clearance from the rear of the appliance to the wall. It is als

7of pipe into the female end until the locking lugs are covered. Twist the female end clockwise an eighth of a turn to lock se

8pipe is permissible if allowed by the appliance manufacturer. The horizontal run of venting must be level, or have a 1/4-inch rise for ever

9horizontally from the centerline of the regulator.(h) Clearance to a service regulator vent outlet: 6 feet minimum.(i) Clearance to non-me